突變結單晶硅太陽電池的初步研究.zip
突變結單晶硅太陽電池的初步研究,包括開題報告，任務書，ppt，翻譯原文和譯文摘要.iabstract..ii1引言..11.1目前單晶硅在光伏產業中的發展現狀11.2 研究本課題所用的方法22實驗方法72.1 設計實驗72.2 本次電池制備所涉及電池結構示意圖72.3實驗步驟93 實驗分析133.1 單晶硅太陽能電池基本特性參數133.2 電池片的i...
該文檔為壓縮文件,包含的文件列表如下:
內容介紹
原文檔由會員 牛奶咖啡 發布
包括開題報告，任務書，ppt，翻譯原文和譯文
摘要…………………………………………………………………………………….I
Abstract……………………………………………………………………………..II
1 引言……..…………………………………………………………………………1
1.1 目前單晶硅在光伏產業中的發展現狀………………………………1
1.2 研究本課題所用的方法…………………………………………………2
2 實驗方法………………………………………………………………………7
2.1 設計實驗…………………………………………………………………7
2.2 本次電池制備所涉及電池結構示意圖………………………………7
2.3 實驗步驟…………………………………………………………9
3 實驗分析……………………………………………………………………13
3.1 單晶硅太陽能電池基本特性參數……………………………………13
3.2 電池片的IV曲線測試…………………………………………………13
3.3 實驗結果分析…………………………………………………………16
4 結論…………………………………………………………………………18
參考文獻…………………………………………………………………………19
致謝…………………………………………………………………………20
突變結單晶硅太陽電池的初步研究
摘 要
突變結結構的pn結相比于緩變結結構的pn結有利于提高器件的光電轉換效率。本課題設計了四種不同結構單晶硅太陽能電池，以分析研究提高太陽電池轉換效率的合理器件結構。采用等離子體增強化學氣相沉積（PECVD）沉積發射極所需的摻雜硅薄膜，并采用快速熱處理（RTP）的方法使得到的薄膜晶化，以獲得最優性能的硅薄膜。對于使發射極薄膜性能的優化研究是針對在石英襯底上沉積薄膜，并熱處理進行的。，利用上述最優條件制備所設計的四種結構的單晶硅太陽電池。將制作好的四塊突變結單晶硅電池片進行IV曲線測試并繪制出每塊電池片的IV曲線。通過曲線分析每塊電池的開路電壓、電流密度、填充因子和電池效率，并把每塊電池的分析結果進行對比，得出了ITO/n-μc-Si/p-c-Si/Al結構的P型突變結單晶硅太陽能電池效果最好。在鹵鎢燈光照條件下，該電池的短路電流密度（J）為11.5mA/cm2，開路電壓（VOC）為0.4V，計算得電池效率（η）為3.8%，填充因子（FF）為0.43。
關鍵字：突變結；快速熱處理；IV曲線；電池效率
The pioneering research on the abrupt junction monocrystalline silicon solar cells
Abstract
Abrupt junction structure of the p-n junction compared with graded junction structure of the p-n junction can help improve the photoelectric conversion efficiency of the device. This topic design procession of four different structure of monocrystalline silicon solar cells, analysis and study how to improve solar cell conversion efficiency. By plasma enhanced chemical vapor deposition (PECVD) technique sedimentary emitter of doped silicon thin film, and by using the method of rapid heat treatment (RTP) to make the film crystallization, in order to obtain the optimal performance of the silicon thin film. To optimize emitter film properties of the research is in view of the film deposited on quartz substrate, and the heat treatment. Designed using the optimal conditions for the preparation of the four kinds of structure of monocrystalline silicon solar cells. IV curves of the solar cells were used to characterize the properties. It is found that the properity of the cell with a structure ITO/n-μc-Si/p-c-Si/Al is the best one. The battery short-circuit current (ISC) is 0.0025 A, open circuit voltage (VOC) is 0.4 V, battery efficiency (η) is 1.9%, the fill factor (FF) is 0.43.
摘要…………………………………………………………………………………….I
Abstract……………………………………………………………………………..II
1 引言……..…………………………………………………………………………1
1.1 目前單晶硅在光伏產業中的發展現狀………………………………1
1.2 研究本課題所用的方法…………………………………………………2
2 實驗方法………………………………………………………………………7
2.1 設計實驗…………………………………………………………………7
2.2 本次電池制備所涉及電池結構示意圖………………………………7
2.3 實驗步驟…………………………………………………………9
3 實驗分析……………………………………………………………………13
3.1 單晶硅太陽能電池基本特性參數……………………………………13
3.2 電池片的IV曲線測試…………………………………………………13
3.3 實驗結果分析…………………………………………………………16
4 結論…………………………………………………………………………18
參考文獻…………………………………………………………………………19
致謝…………………………………………………………………………20
突變結單晶硅太陽電池的初步研究
摘 要
突變結結構的pn結相比于緩變結結構的pn結有利于提高器件的光電轉換效率。本課題設計了四種不同結構單晶硅太陽能電池，以分析研究提高太陽電池轉換效率的合理器件結構。采用等離子體增強化學氣相沉積（PECVD）沉積發射極所需的摻雜硅薄膜，并采用快速熱處理（RTP）的方法使得到的薄膜晶化，以獲得最優性能的硅薄膜。對于使發射極薄膜性能的優化研究是針對在石英襯底上沉積薄膜，并熱處理進行的。，利用上述最優條件制備所設計的四種結構的單晶硅太陽電池。將制作好的四塊突變結單晶硅電池片進行IV曲線測試并繪制出每塊電池片的IV曲線。通過曲線分析每塊電池的開路電壓、電流密度、填充因子和電池效率，并把每塊電池的分析結果進行對比，得出了ITO/n-μc-Si/p-c-Si/Al結構的P型突變結單晶硅太陽能電池效果最好。在鹵鎢燈光照條件下，該電池的短路電流密度（J）為11.5mA/cm2，開路電壓（VOC）為0.4V，計算得電池效率（η）為3.8%，填充因子（FF）為0.43。
關鍵字：突變結；快速熱處理；IV曲線；電池效率
The pioneering research on the abrupt junction monocrystalline silicon solar cells
Abstract
Abrupt junction structure of the p-n junction compared with graded junction structure of the p-n junction can help improve the photoelectric conversion efficiency of the device. This topic design procession of four different structure of monocrystalline silicon solar cells, analysis and study how to improve solar cell conversion efficiency. By plasma enhanced chemical vapor deposition (PECVD) technique sedimentary emitter of doped silicon thin film, and by using the method of rapid heat treatment (RTP) to make the film crystallization, in order to obtain the optimal performance of the silicon thin film. To optimize emitter film properties of the research is in view of the film deposited on quartz substrate, and the heat treatment. Designed using the optimal conditions for the preparation of the four kinds of structure of monocrystalline silicon solar cells. IV curves of the solar cells were used to characterize the properties. It is found that the properity of the cell with a structure ITO/n-μc-Si/p-c-Si/Al is the best one. The battery short-circuit current (ISC) is 0.0025 A, open circuit voltage (VOC) is 0.4 V, battery efficiency (η) is 1.9%, the fill factor (FF) is 0.43.
